TARGET FOR IQ · CURRENT AFFAIRS
JNCASR Terahertz Silicon Chip: 100 Gbit/s Demonstration and Future 6G Research
Current affairs reading · 3 min read · English
On this page
What is the update?
Researchers at JNCASR demonstrated a silicon photonic device that carried data at up to 100 gigabits per second across an engineered barrier. The result concerns compact terahertz circuits and may inform future communication technologies; it is not the launch of a commercial 6G network.
The technical problem
Terahertz frequencies lie between microwaves and infrared radiation and offer wide bandwidth. Guiding them through small circuits is difficult because bends, junctions and abrupt geometric changes can scatter or reflect signals.
The researchers used a photonic crystal formed by triangular holes in a silicon slab. A boundary between differently arranged regions guides the waves. The structure draws on topological photonics and a honeycomb-like arrangement, allowing the team to investigate how signals pass through deliberately introduced obstacles.
What the experiment showed
| Device or measure | Reported result |
|---|---|
| Single engineered barrier | Approximately 1–2% added loss |
| Two barriers in sequence | Approximately 2–3% added loss |
| Double-barrier device | 48 Gbit/s data transmission |
| Omega-shaped device | 60 Gbit/s data transmission |
| Power splitter | 100 Gbit/s using QAM-32 modulation |
| Measurement range | 310–360 GHz |
The 100 Gbit/s result belongs to the splitter configuration. It should not be assigned automatically to every device tested. Likewise, low loss across these engineered barriers does not establish that terahertz signals can pass through arbitrary walls or materials with negligible loss.
How the barrier was engineered
The barrier was produced by changing triangular-hole sizes over a short section of the guide. Transmission stayed near the barrier-free level while the barrier strength remained below a characteristic coupling strength of the crystal. The geometry therefore provides a design parameter that researchers can control.
The team tested three structures on high-resistivity silicon: a double-barrier guide, an omega-shaped path with four sharp bends and a central barrier, and a splitter with a barrier in one branch. Measurements agreed closely with simulations, and the splitter’s two outputs were nearly identical.
Institution, publication and next steps
The work was led at the Jawaharlal Nehru Centre for Advanced Scientific Research, an autonomous institution under the Department of Science and Technology, with collaborators in India, Singapore and France. It was published in Advanced Materials.
The researchers proposed future work on electrical, thermal or mechanical tuning of barriers. Such control could allow signals to be redirected between paths, but this is a next-stage research objective rather than a completed switching capability announced in the result.
Exam perspective
The topic connects semiconductor devices, photonics and high-speed communications. Remember that Gbit/s measures a data rate, while GHz measures frequency. QAM-32 is the modulation method identified for the highest-rate demonstration and encodes information through signal amplitude and phase.
A precise answer describes a laboratory device and its potential relevance. Avoid converting a promising chip experiment into a claim that national 6G services or consumer handsets are already available.
Exam revision
- Institution: JNCASR under DST.
- Technology: silicon photonic crystal for terahertz signals.
- Highest reported rate: 100 Gbit/s in the splitter.
- Test frequency range: 310–360 GHz.
- Publication: Advanced Materials.
- Future 6G relevance is a research prospect, not a deployed service.
Quick questions
Did every tested device transmit at 100 Gbit/s?
No. The double-barrier and omega-shaped devices achieved 48 and 60 Gbit/s; the splitter supported 100 Gbit/s.
Does the experiment show signals passing through any physical wall?
No. It concerns a specifically engineered barrier within a photonic device.
Official references: Ministry of Science & Technology — 2026-11-04.